Salam Academy
Paper 1 · Module

Electric and magnetic fields

9PH0 past papers

11 subtopics≈ 390 min in total
  1. Coulomb's law

    Two point charges exert forces on each other proportional to the product of the charges and inversely proportional to the square of their separation: F=Q1Q24πε0r2F=\dfrac{Q_1Q_2}{4\pi\varepsilon_0r^2}, with ε0=8.85×10−12\varepsilon_0=8.85\times10^{-12} F m⁻¹. Like charges repel; unlike attract. A point charge (or charged sphere, from outside) creates a radial field E=Q4πε0r2E=\dfrac Q{4\pi\varepsilon_0r^2}. Fields from several charges add as vectors.

    ≈ 35 min
  2. Electric fields and uniform fields

    An electric field is a region where a charge experiences a force. Field strength is the force per unit positive charge: E=FqE=\dfrac Fq (N C⁻¹ or V m⁻¹). Between parallel plates with p.d. VV and separation dd, the field is uniform: E=VdE=\dfrac Vd. A charged particle in a uniform field feels a constant force qEqE, so it accelerates uniformly and, if it enters at right angles, follows a parabola like a projectile.

    ≈ 35 min
  3. Electric potential

    Electric potential at a point is the work done per unit positive charge bringing a small test charge from infinity: V=Q4πε0rV=\dfrac Q{4\pi\varepsilon_0r}. Unlike gravitational potential, it can be positive (near a positive charge) or negative. A charge qq at that point has potential energy EP=qV=Qq4πε0rE_P=qV=\dfrac{Qq}{4\pi\varepsilon_0r}. Field strength is minus the potential gradient, E=−ΔVΔrE=-\dfrac{\Delta V}{\Delta r}, so field lines cross equipotentials at right angles.

    ≈ 40 min
  4. Capacitors and capacitance

    A capacitor stores separated charge: +Q+Q on one plate, −Q-Q on the other. Its capacitance is the charge stored per unit p.d.: C=QVC=\dfrac QV, measured in farads (F). An isolated sphere also has capacitance, C=4πε0rC=4\pi\varepsilon_0r. Capacitors in parallel add: C=C1+C2C=C_1+C_2. In series, reciprocals add: 1C=1C1+1C2\dfrac1C=\dfrac1{C_1}+\dfrac1{C_2}, the opposite of resistors.

    ≈ 35 min
  5. Energy stored in a capacitor

    As a capacitor charges, each new bit of charge is pushed onto the plates against a rising p.d., so the p.d.–charge graph is a straight line through the origin. The energy stored is the area under it: W=12QV=12CV2=Q22CW=\tfrac12QV=\tfrac12CV^2=\dfrac{Q^2}{2C}. A battery charging a capacitor supplies QVQV, but only half is stored; the other half is dissipated in the circuit resistance.

    ≈ 30 min
  6. Discharging a capacitor

    When a capacitor discharges through a resistor, the current is proportional to the charge remaining, so charge, p.d. and current all decay exponentially: x=x0e−t/RCx=x_0e^{-t/RC}. The time constant τ=RC\tau=RC is the time for any of them to fall to 1e\dfrac1e (37%37\%) of its starting value. A graph of ln⁡V\ln V against tt is a straight line with gradient −1RC-\dfrac1{RC}.

    ≈ 40 min
  7. Magnetic fields due to currents

    A current produces a magnetic field. Around a straight wire the field lines are concentric circles (right-hand grip rule), weakening with distance. A flat coil's field resembles a short bar magnet; a long solenoid gives a strong, uniform field inside, which a soft iron core greatly increases. Two parallel wires each sit in the other's field, so they exert forces on each other: currents in the same direction attract, opposite directions repel.

    ≈ 30 min
  8. Force on a current-carrying conductor

    A magnetic field is produced by moving charges or permanent magnets. A wire carrying current II in a field of flux density BB feels a force F=BILsin⁡θF=BIL\sin\theta, where θ\theta is the angle between the wire and the field. The force is greatest when they're perpendicular and zero when parallel. Its direction is given by Fleming's left-hand rule. Magnetic flux density is defined as the force per unit current per unit length on a wire at right angles to the field; 11 T =1=1 N A⁻¹ m⁻¹.

    ≈ 35 min
  9. Force on a moving charge

    A charge QQ moving at speed vv through a field BB feels F=BQvsin⁡θF=BQv\sin\theta, always perpendicular to its velocity. So it does no work: the speed stays constant and, in a uniform perpendicular field, the charge moves in a circle of radius r=mvBQr=\dfrac{mv}{BQ}. Crossed electric and magnetic fields let through only charges with v=EBv=\dfrac EB (a velocity selector). In a conductor, the magnetic force pushes carriers to one side, creating the Hall voltage VH=BIntqV_H=\dfrac{BI}{ntq}.

    ≈ 40 min
  10. Electromagnetic induction

    Magnetic flux through an area is Φ=BA\Phi=BA (with BB perpendicular to AA), measured in webers. For a coil of NN turns, flux linkage is NΦN\Phi. Faraday's law: the induced e.m.f. equals the rate of change of flux linkage. Lenz's law: the induced e.m.f. acts to oppose the change that causes it. Together: E=−Δ(NΦ)ΔtE=-\dfrac{\Delta(N\Phi)}{\Delta t}. A conductor of length LL moving at vv through a field BB has E=BLvE=BLv.

    ≈ 40 min
  11. Characteristics of alternating currents

    An alternating current reverses direction periodically: I=I0sin⁡ωtI=I_0\sin\omega t, with peak value I0I_0, period TT and frequency f=1Tf=\dfrac1T. The power in a resistor, I2RI^2R, varies between 00 and I02RI_0^2R, so the mean power is 12I02R\tfrac12I_0^2R. The r.m.s. value is the steady d.c. value giving the same mean power: Irms=I02I_{\text{rms}}=\dfrac{I_0}{\sqrt2} and Vrms=V02V_{\text{rms}}=\dfrac{V_0}{\sqrt2}. Pakistan's mains is 230230 V r.m.s., peaking at about 325325 V.

    ≈ 30 min

What the Edexcel 9PH0 syllabus asks for in electric and magnetic fields

  • 108 Electric fields
  • 109 Electric field strength
  • 110 Coulomb's law
  • 111 Field of a point charge
  • 112 Field and potential
  • 113 Uniform fields
  • 114 Radial potential
  • 115 Field lines and equipotentials
  • 116 Capacitance
  • 117 Energy stored in a capacitor
  • 118 Charging and discharging
  • 119 Capacitor charge and discharge (core practical 11)
  • 120 Exponential discharge equations
  • 121 Magnetic flux and flux linkage
  • 122 Force on a moving charge
  • 123 Force on a current-carrying conductor
  • 124 Induced emf from motion
  • 125 Induced emf from a changing current
  • 126 Lenz's law
  • 127 Faraday's law
  • 128 Alternating current
  • 129 Peak and rms values

Summarised in our own words from the official First teaching 2015 syllabus; each point is taught in the lessons above.