Electromagnets and Motors
A current produces a magnetic field: circles round a straight wire, and a bar-magnet pattern from a solenoid. Wind a solenoid round soft iron and you have an electromagnet. A current-carrying wire in a magnetic field feels a force, and in a d.c. motor that force turns a coil, with a split-ring commutator reversing the current every half turn.
Builds on: Magnetism and magnetic fields, Charge, current and potential difference
On the AQA 8463 syllabus (First teaching 2016): 4 points this lesson covers
- 4.7.2.1 Electromagnetism
- 4.7.2.2 Fleming's left-hand rule and F = BIl
- 4.7.2.3 Electric motors
- 4.7.2.4 Loudspeakers
Summarised in our own words from the official syllabus. Check the exact wording in the board's specification.
Learning objectives
- Describe the magnetic field of a straight wire and of a solenoid.
- Explain how electromagnets work and give uses.
- Describe the force on a current-carrying conductor and use Fleming's left-hand rule.
- Explain how a d.c. motor works and how to make it turn faster.
A loudspeaker has no moving parts except a cone attached to a coil, sitting near a magnet. How can an electrical signal make it move back and forth?
Core idea
Lay a wire between magnet poles and switch on a current: the wire jumps sideways. Current and field together make a force. Bend the wire into a coil and the forces make it spin: an electric motor.
Current makes a field. Current in a field feels a force (Fleming's left-hand rule). A coil turns; a split-ring commutator keeps it turning.
1. Fields from currents
- Straight wire: circles (right-hand grip rule).
- Solenoid: like a bar magnet; iron core strengthens it.
2. The motor effect
- Left hand: First finger Field, seCond finger Current, thuMb Motion.
- Commutator reverses the current every half turn so the turning force keeps the same sense.
Make it faster; reverse it.
- Goal
- Changes.
- Strategy
- Force depends on current, field, turns.
Faster: more current, stronger magnets, more turns.
Reverse: swap the current direction or the field.
Why does a wire parallel to the field feel no force?
- Current in a field
A current-carrying coil sits between the poles of a magnet.
- Forces
The two long sides carry current in opposite directions, so by Fleming\'s left-hand rule they feel forces in opposite directions.
- Turning effect
The forces form a couple, so the coil turns.
- Split-ring commutator
Every half turn it reverses the current in the coil, so the forces keep turning it the same way.
- Faster motor
More current, more turns, a stronger magnet, or a soft iron core.
Why does a motor stop if the commutator is replaced by plain slip rings?
Summary
- Current → field.
- Field + current → force.
- Commutator
- Reverses current in a motor coil.
Also on your syllabus
- Plotting the field round a wire. Pass a vertical wire through a horizontal card. Switch on a large current and place small plotting compasses on the card round the wire: they point along circles centred on the wire. Reverse the current and every compass reverses. Sprinkling iron filings and tapping the card shows the same circular pattern.
- Relays. A small current in a relay's coil makes an electromagnet that pulls an iron armature, closing (or opening) a second, separate switch. A small, safe current can then switch on a large current, such as a car's starter motor.
- Beams of charged particles. A beam of electrons is a current, so a magnetic field pushes on it just as on a wire. Use the left-hand rule with the current direction opposite to the electron motion (electrons are negative). A beam of positive particles is deflected the opposite way to an electron beam.
- Parallel currents. Two long parallel wires carrying currents in the same direction attract; currents in opposite directions repel. Between same-direction currents the two circular fields point opposite ways and partly cancel, so the field lines wrap round both wires and pull them together.
- where
- F
- force in newtons (N)
- B
- magnetic flux density in tesla (T)
- I
- current in amperes (A)
- l
- length of wire in the field, in metres (m)
- Relays and loudspeakers: in a relay, a small current in an electromagnet closes a switch in a second circuit; in a loudspeaker, a varying current in a coil in a magnet's field makes the coil and cone vibrate, producing sound.
Create a free account to read the rest of this lesson: key formulae, worked examples, explore the graph, common mistakes, exam tip, guided practice and more. Your answers are checked and your progress is saved.