Salam Academy
Particle model of matter · Subtopic 4 of 4

Thermal Expansion and Specific Heat Capacity

Heating makes particles move faster and push further apart, so most materials expand: gases most, liquids less, solids least. Heating also raises the internal energy. The energy needed for a temperature rise depends on the mass and the material: ΔE=mcΔθ\Delta E=mc\Delta\theta, where cc is the specific heat capacity.

8463 past papers

Cambridge 5054 Paper 1Cambridge 5054 Paper 2Cambridge 0625 Papers 2, 4Cambridge 0625 Papers 1, 3Edexcel 4PH1 Paper 1PEdexcel 4PH1 Paper 2P≈ 30 minRevision 10 · updated

Builds on: Kinetic particle model and gases, Energy, work and power

On the AQA 8463 syllabus (First teaching 2016): 3 points this lesson covers
  • 4.1.1.3 Specific heat capacity (RP1)
  • 4.3.2.1 Internal energy
  • 4.3.2.2 Specific heat capacity

Summarised in our own words from the official syllabus. Check the exact wording in the board's specification.

Section 1 of 14

Learning objectives

  • Describe thermal expansion and give uses and problems it causes.
  • Explain the order of expansion of gases, liquids and solids.
  • Use ΔE=mcΔθ\Delta E=mc\Delta\theta to find energy, mass, cc or temperature change.
  • Describe an experiment to measure specific heat capacity.
Pause and think

On a hot beach, sand burns your feet but the sea feels cool, even though the Sun shines equally on both. Why?

Section 2 of 14

Core idea

Start hereHot sand, cool sea

On a sunny day the sand burns your feet while the sea stays cool, though both get the same sunshine. Water needs far more energy to warm up by each degree. That property is its specific heat capacity.

The big idea

E=mcΔθE=mc\Delta\theta, cc in J/kg °C. Most materials expand when heated.

1. Specific heat capacity

Heating 1 kg of water and 1 kg of aluminium with the same heater
10203040501020304050600energy supplied (kJ)temperature rise (°C)water: c = 4200 J/(kg °C)aluminium: c = 900
Water needs much more energy per degree, so it heats up slowly and cools slowly. That is why it is used in radiators and why coastal climates are milder.
E=mcΔθE=mc\Delta\theta
where
EE
energy supplied (J).
mm
mass (kg).
cc
specific heat capacity (J/kg °C).
Δθ\Delta\theta
temperature change (°C).
Worked exampleWater vs aluminium

Warm 1 kg of each by 20 °C (c=4200c=4200, 900900).

Goal
Energies.
Strategy
Formula.
  1. 1×4200×20=84000 J1\times4200\times20=84000\text{ J}
    Water.
  2. 1×900×20=18000 J1\times900\times20=18000\text{ J}
    Aluminium.
Answer8484 kJ vs 1818 kJ.
✓ CheckRatio 4200/900=4.74200/900=4.7 ✓: why water stores heat well.
Worked exampleMeasuring c

50 W heater for 5 min warms 0.5 kg of oil by 15 °C.

Goal
cc.
Strategy
E=PtE=Pt, then rearrange.
  1. E=50×300=15000 JE=50\times300=15000\text{ J}
    5 min = 300 s.
  2. c=150000.5×15=2000c=\frac{15000}{0.5\times15}=2000
    Rearrange.
Answer20002000 J/kg °C.
✓ CheckHeat lost to the room makes this an overestimate ✓.
Common misconceptionMinutes Power × time needs time in seconds.

2. Thermal expansion

Gaps in railway lines and sagging power cables allow for expansion
gapin summer the rails expand and close the gap
Without gaps, hot rails would buckle. A bimetallic strip (two metals expanding by different amounts) bends when heated and is used in thermostats.
  • Particles vibrate more and push slightly apart.
  • Gases expand most, then liquids, then solids.
  • Uses: thermometers, bimetallic strips.
Pause and think

Why do bridges have expansion joints?

Quick check

Why is water a good choice to fill central-heating radiators?

Summary

  • E=mcΔθE=mc\Delta\theta.
  • Expansion: allow gaps.
Key words
Specific heat capacity
Energy to raise 1 kg by 1 °C.

Also on your syllabus

  • Internal energy. The internal energy of an object is the total energy of all its particles (their kinetic energy plus the potential energy stored by the forces between them). Heating an object raises its temperature and so increases its internal energy.
  • What temperature measures. A rise in temperature means the particles are moving faster on average: temperature is a measure of the average kinetic energy of the particles. Two objects at the same temperature have particles with the same average kinetic energy, even if one object is much bigger and so has more internal energy.
Pause and think

A bath of warm water and a cup of boiling water. Which has more internal energy? Which particles have the higher average kinetic energy?

  • Experiment: specific heat capacity. Heat a known mass with an electric heater, measure the energy supplied (joulemeter, or E=VItE=VIt) and the temperature rise; c=EmΔθc=\frac{E}{m\Delta\theta}. Insulate the block to reduce heat loss.
HistoryBlack and "latent" heat. Joseph Black, a Scottish chemist, noticed in the 17601760s that equal masses of different substances needed different amounts of heat for the same temperature rise. His idea of "heat capacity" separated temperature (how hot) from heat (how much energy).
Fun factThe Eiffel Tower grows in summer. The Eiffel Tower is about 1515 cm taller on a hot summer day than on a cold winter one, because its 73007300 tonnes of iron expand with heat.
Keep reading for free

Create a free account to read the rest of this lesson: key formulae, worked examples, explore the graph, common mistakes, exam tip, guided practice and more. Your answers are checked and your progress is saved.